One of the most highly reviewed and tested Starlink mount for vehicles and boats has arrived in Australia!

The TRIO Starlink GEN 3 Flatmount and Rubber Coated Magnets Pack is a sleek and secure mounting solution for those looking to install their Gen 3 Standard Starlink dish on a boat, caravan, RV, or vehicle. With a simple press of the tabs on the Starlink kickstand, you can easily slide out the stand and slide in the TRIO Flatmount until it clicks securely into place.

It also comes with Rubber Coated Magnetic Feet to permanently or temporarily attach to a magnetic surface. The set of 4 rubber coated magnets with female threads allow for M6 screws (for gen 3 mounts) to easily tighten in place. Stainless steel hardware included.

• Magnet dimensions: 600mm Diameter x 8mm High

• Holding Force: 27kg (each)

Designed for both permanent and temporary installations, the Gen 3 TRIO Flatmount is versatile enough for vans, motorhomes, 4WDs, campers, boats, sailboats, and more with various mounting options available. 

Note: For vehicles with curved roofs, the mount has a slight flex, but you may need our pivoting leg adapters for optimal surface area contact when using rubber-coated magnets, VHB landing pads, or suction cups. Be sure to add these to your order if needed.

Release Lever: Fixed mount options (through bolt and VHB adhesive) come with a custom-designed lever, allowing easy removal of the dish when desired. This feature lets you quickly remove the dish from the vehicle and reinstall the Starlink kickstand to use in another location, such as at home or when parked under trees.

Strength: The TRIO Flatmount is designed and tested for normal driving conditions and turbulence. However, it is recommended to install it behind another item, such as an AC unit or storage box, for wind dampening and dish protection. Users should ensure the antenna mount is securely installed. For fully exposed locations or highway speeds, we recommend the Gen 3 Speedmount.

Assembled Dimensions
Length: 305 mm
Width: 254 mm
Height: 38 mm
(Total height to top of Gen 3 dish when mounted is 50mm)

Colour Options
White or Black

Mounting Options
This TRIO Starlink mount does not come with other fixing accessories. We offer a range of mounting fixtures using the mount's four fixing points to suit your application:

• Through-bolt - to permanently screw into to a solid surface or rack accessory
• VHB Adhesive Landing Pads - adhesive pads to permanently bond to a solid surface 
• VHB Adhesive Backed Magnet Mounting Discs + Magnetic Feet - to temporarily attach to a surface that is not magnetic
• Suction Cups - to permanently or temporarily attach to an even and no-porous surface

** Designed and tested for high speeds, but ensure the antenna mount is secured appropriately. Using Starlink™ in motion may violate your Terms of Service depending on your service location. Consult your Terms of Service to determine if this applies to you. Given the varying conditions of surfaces this can be mounted to, it is ultimately up to the end user to make sure the antenna mount is sufficiently secured. By purchasing and using this product, you agree to waive any claims that you may have against Powertec, and included entities, from any and all liability for any loss, damage, expense or injury, including death, that may suffer as a result of the use of the product, due to any cause whatsoever.